Here's what I've done to my
1972 yellow Land and Sea Trailer that came with 14.5 ST tires.
Go to 16" LT (light
truck) tires - I use the same ones I have on my E350 Ford (1 ton) van.
Tires
Dextero DHT2 Tire P245/75R16 109T
16" rims:
Rims
Taskmaster
Steel 8-Spoke Trailer Wheel - 16" x 6" Rim - 6 on 5-1/2
The 16's
won't fit under the fender so the additional clearance is accomplished using a
taller equalizer:
Equalizer
Triangular Equalizer for
1-3/4" Double-Eye Springs - 6-1/16" Long - 9/16" Center Hole
I also replaced my springs
25 1/4 double eye
Wet Shackles
Dexter Heavy
Duty Suspension Upgrade Kit for Single Axle Trailers - Double Eye Springs
Tie plates that hold the
springs against the axle (be sure to torque these)
Tie Plates
Rockwell Tie Plate Kit for
2" Square Trailer Axle
Nev-R Adjust brakes (need
left and right)
Backing
plates
Self adjusting brakes are
nice, but the hubs can be hard to remove to check bearings.
New upgraded hubs (and above
brakes) for maximum braking
Hubs
6,000lb hubs vs the 5,200
that came on the trailer.
BTW - I removed all the bearings and races from the new hubs in favor of Timkin.
Off brand bearings
I get by fine with the
electric brakes but I'm a very conservative driver. I'm thinking that EOH might
be better for ultimate braking but I'm not willing to endure the complication.
Here's some more reading regarding the trailer if you're inclined.
Dextero DHT2 Tire P245/75R16 109T
Rims
Equalizer
Tie Plates
Backing plates
Hubs
BTW - I removed all the bearings and races from the new hubs in favor of Timkin.
Off brand bearings
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.