The first thing we noticed when bringing her home, was that the door wouldn't close. We'd mentioned this to the salesman and they told me they fixed it, but it wasn't fixed...just made to work temporarily. They snugged the screws in the frame latch which was good for about 2 closings...
Tiny sheet metal screw vs stainless machine screw. |
Then about 20 miles into our first outing from SC to FL I stopped to torque the trailer lug nuts and check inside the trailer. The trailer floor was covered in water, as was the galley counter and water was was dripping out of the cabinet overhead. This was very puzzling as the trailer had never been exposed to rain of any kind. The only thing I can figure was that the water was in the roof or wall when we took delivery and it wasn't until we were on the road in temps above freezing that it became a problem. Then again, the folks at the dealership did mention Dicor self leveling lap sealant several times?
I'm not getting ballistic about the water -- I'll come to grips with the problem, but it is a shame that when the compressed sawdust they use for interior wood gets wet, the printed grain on it bubbles.
This video was taken after we returned home and ran the pump for 20 minutes.
On the second night, when we wanted to take showers, we got very little water out of the tub faucet, just a hissing mist. Thankfully our first stop in Florida was a friend who let us use their shower. While there, I refilled the water tank, but with the same hissing results. My wife has MS, uses a wheelchair and didn't need any complications, and we had two more stops before heading home so we decided to just live with the problem until we got home. We bought half dozen "Bath Bags" (like moistened wipes but designed for giving baths to bedridden patients) to use for the remainder of the trip.
Another thing we noticed when we got to Florida was that the 50psi we put in the tires at home, was now 58psi and the tires were showing wear typical of overly inflated tires. Having traveled to Alaska twice, we were prepared to monitor the single axle tires with a TPMS system.
The top numbers are for the back tires of the van. The bottom numbers are for the trailer. |
So now back home, I decided to find out what the plumbing problem is. I disassembled the galley cabinet and divider, then watched the filter when the faucet was hissing. There didn't seem to be any air in the system at that point, but just to be sure I took the plate off at the tub and followed the hose back to the tank - sure enough, an uncomplicated run. I gandered at the hose/tank junction while the faucet was hissing and still couldn't see bubbles. To me, this meant the pump had to come out.
Getting the pump out requires contortion and patience. The electrical connections and plumbing hoses have to be executed while lying in the isle with ones arms stretched under the cabinet. This is complicated by not knowing what kind of fasteners were used to mount the pump, and further by those fasteners not being used in the allotted holes, especially when everything has to be done by feel.
Close, but no cigar. There were two like this. |
Evidently, someone was in a hurry when the filter assembly was attached.
So now, we'll see if we can get any satisfaction from the dealer in respect for my troubles. Hopefully a new pump and at least what he'd pay his mechanics to do the repairs?
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.