Tuesday, June 18, 2013

Dust Cap Pliers


Oh no, it’s that time again when I should have a look at my trailer wheel bearings. Get out the hammer and screwdriver and tap it in into the crack on the dust cap, then whack it back and forth to get it off. Hope I didn’t deform the dust cap or worse yet poke a hole in it.


It’s tough to spend $30 on a tool you won’t use that often, but this is one of them.
Dust Cap Pliers.


You may have to give them a slight tap with a hammer to set them, but then the cap will come off easily without damage.

And you can likely find a piece of plastic or metal pipe the will fit over the cap and allow you to tap it in via the rim instead of hammering on the dome.

Now you’ll look forward to wheel bearing maintenance!


No comments:

Post a Comment

Note: Only a member of this blog may post a comment.